Body sculpturing truSculpt flex
Pump up your body in 4 treatments, instead of 6 months in the gym.
Pump up your body in 4 treatments, instead of 6 months in the gym.
How to train muscles? Our answer is device truSculpt® flex. This is a muscle training device, body modeling and weight loss. TruSculpt® flex – is an ideal solution for building the abdominals, thighs and buttocks.
Sculpting muscles without sports in 3 weeks is real. During the procedure, the muscles are strengthened, their tone is increased, the skin is tightened and its elasticity is increased, and the body contour is created.
Myostimulation with the truSculpt® flex device occurs without pain and rehabilitation [1]. The procedure is very comfortable. A real workout, only while you lie down and relax. You can go back to your chores right after the procedure.
truSculpt® flex is the most popular red carpet body preparation in 2021.
Muscle building with the truSculpt® flex is achieved through Multi-Directional Stimulation (MDS). This is a unique electrical stimulation of specific muscle groups using three training regimen options, covering the largest area of influence among all such devices.
Three modes are designed to simulate different types of workouts:
1. Preparatory mode – creates a twisting motion. Thus, it is possible to warm, stretch the muscles, gradually develop an adjusting to muscle contractions.
2. Tonal mode – contracts muscles, holds them until exhaustion, and then relaxes. As a result, there is an increase in muscle strength and endurance.
3. Sculpting mode – fast and deep consecutive muscle contractions, the purpose of which is to build muscle mass and increase the metabolic rate (BMR) in muscle tissue.
Low energy provides deep muscle contraction with high intensity thanks to the proprietary truGel tip design.
truSculpt ® flex is the most advanced and expensive FDA approved muscle pump in the world [2].
EMSculpt belongs to the same group of devices. The group is the same, but the result is completely different.
truSculpt flex | EMSculpt | |
Mode of action | Bioelectrical stimulation | magnetic impact |
Training results | Increase in muscle mass up to 30% and weight loss in the affected area up to 24% | Up to 16% increase in muscle mass |
Maximum exposure area per workout | 8 zones, making up about 1009 cm square. body surface | 2 zones constituting 364 cm2 of body surface |
Workout time | 45 min for 8 zones | 30 min for 2 zones |
Number of tips | 16 | 2 |
Mode of action | Direct electrical stimulation of selected muscles | The impact of a large nozzle on one area on the body (loss of impact due to dispersion) |
Impact power | 10-30mA | 1.9 tesla, which corresponds to about 30 mA (one mode) |
Maximum power at the point of impact | (three different modes for people with different physical fitness) | 30 mA is dissipated over the entire surface. As a result, the direct effect on the muscle is negligible. |
Although in clinical studies the result was recorded even after one procedure [3], the minimum required number of sessions for a visible result is 4-6 procedures. Treatment sessions should be carried out at intervals of 2 to 5 days, but not more than 7 days.
It is optimal to carry out 2 procedures per week. 4-6 procedures replace 6 months of regular exhausting sports.
Thus, in just 2-3 weeks you will carry out a complete modeling and sculpting of your body.
Muscle tone and contour continue to improve over several weeks, and many of our clients see continuous improvement over several months.
Maintenance procedures can be performed every 1-3 months or as needed.
The truSculpt flex device uses electrical stimulation to tone and firm the abdominal muscles, develop a firmer abdomen, and firm, tone and firm the buttocks and thighs in a very short time. It helps to get rid of extra pounds, acquire muscle relief and aesthetic body contours.
It is ideal for people:
Before starting the procedure, you need to visit a doctor. The doctor will determine the presence of contraindications, listen to the wishes and draw up a training program for the truSculpt flex device.
There is no need for additional examinations. Before the procedure, you need to drink plenty of water. 12 hours before the start of treatment, it is not recommended to exercise and, if necessary, shave the treated area before truSculpt flex.
It all starts with the markings for the placement of the tips. Next, the patient lies comfortably on the couch, the doctor sticks truGel to the patient’s skin in the affected area and carefully attaches 2 tips to each truGel. The tips are placed at a distance of at least 2 cm and not more than 20 cm from each other. After attaching all the tips, the doctor wraps the patient with a belt to fix the tips and selects the desired training mode. At the beginning of treatment, patients feel a slight tingling sensation, and as the intensity setting is increased, muscle contraction increases.
No special regimen is followed after the procedure. In some cases, temporary phenomena may occur, such as:
The effect of truSculpt flex training is visible after the first procedure.
Device body shaping includes:
Injection methods for body shaping include injection of:
Surgical methods of correction are very extensive:
Device correction of the body can be used as an independent method, or combined with other methods of correction.
References: